eprintid: 61594
rev_number: 10
eprint_status: archive
userid: 12460
dir: disk0/00/06/15/94
datestamp: 2023-10-20 06:35:54
lastmod: 2023-10-20 06:35:54
status_changed: 2023-10-20 06:35:54
type: thesis
metadata_visibility: show
contact_email: muh.khabib@uin-suka.ac.id
creators_name: Yudhaka Janardana W, NIM.: 19106060038
title: ANALISIS PENGENDALIAN KUALITAS DENGAN METODE SIX SIGMA UNTUK MENGURANGI CACAT DALAM PRODUKSI KOMPONEN  (STUDI KASUS PADA PT. ALIS JAYA CIPTATAMA)
ispublished: pub
subjects: TA
divisions: jur_tind
full_text_status: restricted
keywords: Kecacatan Produk, Six Sigma DMAIC, Kualitas, Komponen WE.18.03, Mill 1
note: Pembimbing: Ir. Trio Yonathan Teja Kusuma, S.T., M.T., IPM.
abstract: This research was conducted at PT Alis Jaya Ciptatama to analyze quality control in the production process of component WE.18.03 in Mill 1. The maximum target percentage of product acceptance that is defective by the company from each production is 2%. However, there are several problems and the amount of production is erratic so that it can cause the amount of production that experiences defects to exceed the maximum percentage limit, which is 3% to 5% in the Mill 1 section in each production. From the analysis and discussion, the types of product defects include cracked holes, knots, laminations, fibers, and colors. The resulting sigma and DPMO values are 4.67 and 46,934.74. Factors causing defects include humans, methods, environment, materials, and machines that cause problems in the production process. The method used in this research is Six Sigma with the DMAIC approach (Define, Measure, Analyze, Improve, and Control). The proposed improvement solutions are supervising and directing the production process, cycle time accuracy, creating work schemes, implementing raw material inspection procedures, checking and maintaining machines, examining the quality of raw materials, and improving the safety and cleanliness of the work environment. With the implementation of these corrective measures, it is expected to minimize the number of defects in component WE.18.03 and improve the company's product quality in a sustainable manner.
date: 2023-08-21
date_type: published
pages: 135
institution: UIN SUNAN KALIJAGA YOGYAKARTA
department: FAKULTAS SAINS DAN TEKNOLOGI
thesis_type: skripsi
thesis_name: other
citation:   Yudhaka Janardana W, NIM.: 19106060038  (2023) ANALISIS PENGENDALIAN KUALITAS DENGAN METODE SIX SIGMA UNTUK MENGURANGI CACAT DALAM PRODUKSI KOMPONEN (STUDI KASUS PADA PT. ALIS JAYA CIPTATAMA).  Skripsi thesis, UIN SUNAN KALIJAGA YOGYAKARTA.   
document_url: https://digilib.uin-suka.ac.id/id/eprint/61594/1/19106060038_BAB-I_IV-atau-V_DAFTAR-PUSTAKA.pdf
document_url: https://digilib.uin-suka.ac.id/id/eprint/61594/2/19106060038_BAB-II_sampai_SEBELUM-BAB-TERAKHIR.pdf