Institutional Repository UIN Sunan Kalijaga YogyakartaOPTIMASI PARAMETER CNC PLASMA CUTTING TERHADAP AKURASI DIMENSI PADA HASIL PEMOTONGAN PLAT STAINLESS STEEL 430 MENGGUNAKAN METODE TAGUCHI (STUDI KASUS: LABORATORIUM TEKNIK INDUSTRI UIN SUNAN KALIJAGA)NIM.: 22106060069Nabil Miftahul HudaauthorThe CNC plasma cutting process is a non-conventional cutting method widely used in the manufacturing industry due to its ability to produce fast and precise cuts. However, dimensional inaccuracies between the cutting results and the intended design were still found during the cutting of Stainless Steel 430 plates at the Industrial Engineering Laboratory of UIN Sunan Kalijaga Yogyakarta. These inaccuracies were caused by process parameters that had not yet been optimized. This study employed the Design of Experiment (DOE) approach using the Taguchi method with an L9 orthogonal array consisting of four factors and three levels: cutting speed (1000, 1200, and 1400 mm/min), gas pressure (80, 85, and 90 psi), electric current (25, 30, and 35 A), and nozzle height (1, 1.5, and 2 mm). The experiment consisted of nine trials with two replications for each trial, resulting in a total of eighteen experimental runs. Based on the Signal-to-Noise (S/N) ratio analysis, the optimal parameter combination for achieving the smallest dimensional gap was a cutting speed of 1000 mm/min (1.960 dB), gas pressure of 80 psi (0.839 dB), electric current of 35 A (0.771 dB), and nozzle height of 1 mm (1.001 dB). One-way ANOVA results showed that cutting speed contributed 67.71% and nozzle height 15.34% to dimensional accuracy, while electric current and gas pressure each contributed less than 5%. Confirmation experiments verified the effectiveness of the optimal parameter combination in minimizing dimensional deviations. Therefore, this study provides practical recommendations for improving cutting quality in both industrial applications and educational laboratory activities.670 Teknik Industri2026-05-26UIN SUNAN KALIJAGA YOGYAKARTA;FAKULTAS SAINS DAN TEKNOLOGIThesis

For work being deposited by its own author: In self-archiving this collection of files and associated bibliographic metadata, I grant Institutional Repository UIN Sunan Kalijaga Yogyakarta the right to store them and to make them permanently available publicly for free on-line. I declare that this material is my own intellectual property and I understand that Institutional Repository UIN Sunan Kalijaga Yogyakarta does not assume any responsibility if there is any breach of copyright in distributing these files or metadata. (All authors are urged to prominently assert their copyright on the title page of their work.)

For work being deposited by someone other than its author: I hereby declare that the collection of files and associated bibliographic metadata that I am archiving at Institutional Repository UIN Sunan Kalijaga Yogyakarta) is in the public domain. If this is not the case, I accept full responsibility for any breach of copyright that distributing these files or metadata may entail.

Clicking on the deposit button indicates your agreement to these terms.